Home / MiSTer FPGA - Full Setups & Addons / MiSTer Products and Addons / MiSTer HDMI to 1084S DIRECT VIDEO MiSTer HDMI to 1084S DIRECT VIDEO€39,90 (excl. VAT) New Direct Video cable based on AG6200 DAC chip that allows you to connect your Digital / HDMI MiSTer FPGA to a classic 15khz Commodore 1084s monitors for a complete retro experience. Made with Italian brand PREMIUM high quality shielded cable and optimized to work with the MiSTer FPGA. This cable is specific for MiSTer, we do not recommend using it on other systems (if you do, do it at your own risk). If you need a cable with a different connection, contact us first. To avoid any issue we recommend that you back up first your mister.ini file and put a new one with a new configuration. Specification: Connector A: HDMI Connector B: 9 pin D Sub Male (1084s) Connector C: 2 x Stereo RCA Cable Length: 1,6mt MiSTer.ini config: composite_sync = 1 forced_scandoubler = 0 vga_scaler=0 direct_video=1 Scandoubler config setting in menu (F12) OFF in all cores Out of stock Get an alert when the product is in stock: Get an alert Description Description Compatibility Direct Video is compatible with most current cores and will be supported in all future cores coming to MiSTer. RGBs, RGsB and YPbPr are supported, although YPbPr has less display compatibility in Direct Video mode compared to YPbPr from the IO Board. Note that output resolution and format can vary from core to core. How to Use Based on the chip AG6200/AG6201 are proven to work fine on most MiSTer Cores. The only thing we recommend is to not hotplug them or pull them out from your MiSTer while it is still ON, since you might damage your HDMI port in the process. Then you need to add the following line to your mister.ini file: direct_video=1 This activates the Direct Video feature when the system starts. Once it’s enabled, it allows your HDMI port to output the raw and unprocessed digital audio/video signal from the loaded core, which is consumed by your DAC. MiSTer will not work with your HD TV or monitor while this mode is enabled, since they require a standard HDMI signal to work, and the zero-lag Direct Video signal IS NOT standard HDMI. The resulting analog video signal from your DAC should be compatible with standard CRTs if the core loaded supports standard CRT refresh frequencies (see analog video compatibility for more details). But there is still a bit of additional configuration you need to do depending on which kind of analog video signal you want to use.