MiSTer VGA to RGB SCART Lightgun Ready
€25,90 (excl. VAT)
Connect your MiSTer FPGA to a classic 15khz CRT monitors for a complete retro experience. This model also allows you to use your Namco Gun Con 2 with multiple cores and 1x or 2x Players simultaneous.
A 470 ohm resistor has been installed on the corresponding SCART synchronization pin in order to attenuate this signal to safe levels for all video equipment.
Specification:
- Connector A: 15 Pin D-sub (MiSTer video input)
- Connector B: EuroSCART (CRT video output)
- Connector C: 3.5mm stereo jack (MiSTer audio input)
- Connector D: RCA for Namco Gun Con 2
- Cable Length: 1,6mt (default)
- Color: Black
Description
Made with PREMIUM high quality shielded cable and optimized to work with the MiSTer FPGA.
- VGA pin 13 connects to SCART pin 20 (with attenuation of 470 ohm)
- VGA pin 14 connects to SCART pin 16 directly (1,6v or less, no attenuation required)
- Our cable does not use VGA PIN 9.
For analog 15 khz RGB output, you need to change the settings in the mister.ini file. To avoid any issue we recommend that you back up first your configuration file (mister.ini) and put a new one with a new configuration.
MiSTer.ini config:
- forced_scandoubler = 0
- composite_sync = 1
- vga_scaler = 0
- direct_video = 0 **
** this option must be = 1 (enabled) just if you use HDMI to VGA DAC dongles with direct video
* Setup instructions for using the Namco GunCon 2 lightgun with the MiSTer FPGA. Credits to Nolan Nicholson
Notes: Scandoubler config setting in OSD menu (F12) OFF in all cores. This SCART cable is specific for MiSTer, we do not recommend using it on other systems (if you do, do it at your own risk).
Additional information
| Weight | 0,300 kg |
|---|
