Ultimate MiSTer PRO BlisSTer DUAL RAM

499,90 (excl. VAT)

Want to use your MiSTer with original console gamepads or joysticks? BlisSTer Edition with dual low latency / gamepad ports is the right solution for you. 

– Official MiSTer Digital I/O Board 1.2
– Built-In On / Off Power Switch
– Mini-TOSLINK & Digital TOSLINK Connector
– 3.5mm for Audio In (Tape / Cassete Input)
Free GPIO Slot for expansions (Extra RAM)
– Official Memory Module XS-D 128MB SDRAM (PSX, Jaguar, NeoGeo, System 16 and CPS cores compatible), 48Mhz and 96Mhz tested
BlisSter rev.2 Hub Board with flash firmware (check bottom)
– 2 x Low-latency Ports
– Wakefield-Vette Heatsink
– Official Stormtrooper Case – BlisSter Edition
– TerasIC DE10-nano (Cyclone® V SoC)
PSU 2A (US plug, may need adapter depending of country)
– SD Card Starter Pack (Latest firmware and all cores installed)

LOW LATENCY cable adapters not included, need to be acquired separately.

HDMI and DIGITAL AUDIO OUTPUT ONLY – This unit don’t include VGA Port. For analog 240p output must be used a Direct Video Cable.

Equipment full assembled, includes original DE10-nano Box and is ready to plug and play!
Memory module compatible with new CPS 1.5 and 2.0 cores. For every setup sold, a part is donated to MiSTer FPGA software development. We are approve resellers for Bliss-Box. You can link to the authenticity page.

4 in stock

New cables that make use of the 2 existent Low-Latency ports, allowing you to connect legacy / original console and computer gamepads to your MiSTer

Joystick REQUIRE DB9 Adapter. Great for computer cores like Amiga, Atari, Commodore, Spectrum and others.


Compatible only with original and authentic Bliss-box cables. We do not give support to counterfeit/cheap knock-offs. Using unauthorized hardware voids your warranty due to the high probability of devices such as the BlisSTer and Gamer-PRO getting damaged.

Firmware Update Instructions:

Update Script (Included in SDCARD > Scripts Folder):